- ページ 10

電動工具 Makita BJV180のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita BJV180 13 ページ。 Cordless jig saw
Makita BJV180 にも：部品内訳 (3 ページ), 仕様書 (2 ページ), 取扱説明書 (13 ページ), 取扱説明書 (13 ページ), 技術情報 (13 ページ), 取扱説明書 (18 ページ)

ページを印刷する

007499

When cutting circles or arcs of 170 mm or less in

radius, install the rip fence as follows.

Insert the rip fence into the rectangular hole on the

•

side of the base with the fence guide facing up.

Insert the circular guide pin through either of the

two holes on the fence guide. Screw the threaded

knob onto the pin to secure the pin.

Now slide the rip fence to the desired cutting radius,

•

and tighten the bolt to secure it in place. Then

move the base all the way forward.

NOTE:

Always use blades No. B-17, B-18, B-26 or B-27

•

when cutting circles or arcs.

Guide rail adapter set (accessory)

007500

When cutting parallel and uniform width or cutting

straight, the use of the guide rail and the guide rail

adapter will assure the production of fast and clean cuts.

To install the guide rail adapter, insert the rule bar into

the square hole of the base as far as it goes. Secure the

bolt with the hex wrench securely.

007501

Install the guide rail adapter on the rail of the guide rail.

1. Fence guide

2. Threaded knob

3. Circular guide

1. Bolt

2. Rule bar

Insert the rule bar into the square hole of the guide rail

adapter. Put the base to the side of the guide rail, and

secure the bolt securely.

007502

CAUTION:

Always use blades No. B-8, B-13, B-16, B-17 or 58

•

when using the guide rail and the guide rail

adapter.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before attempting to

perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

007505

1. Guide rail

adapter

2. Screw

3. Guide rail

1. Limit mark

1. Brush holder

cap

2. Screwdriver