Makita BJV180 Informazioni tecniche - Pagina 13

Sfoglia online o scarica il pdf Informazioni tecniche per Utensile elettrico Makita BJV180. Makita BJV180 13. Cordless jig saw
Anche per Makita BJV180: Ripartizione delle parti (3 pagine), Scheda tecnica (2 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (18 pagine)

iring diagram

Wiring in Handle (L)

Route Lead wires as illustrated in Fig. 43.

1 Lead wires of Endbell (black):

Route between the rib and the boss, and connect to No.M1 terminal of Switch.

Note: Be sure to fix with Lead wire holder A.

2 Lead wires of Endbell (red):

Route between the rib and the boss, and connect to No.M2 terminal of Switch.

Note: Be sure to fix with Lead wire holders A and B.

3 Lead wire of Switch (black):

Connect to minus pole of Terminal

Note: Be sure to fix with Lead wire holder A.

4 Lead wire of Switch (orange):

Connect this lead wire to plus pole of Terminal.

Note: Be sure to fix with Lead wire holder A.

5 Lead wire of Light circuit:

Route between the pin and the inside wall of Handle (L).

Fig. 43

Lead wires of Endbell (red, black)

must be tight in this area.

Lead wire holder B

Lead wire holder A

Terminal

Endbell complete

Assembling Heat sink to Handle (L)

Switch

Switch lever

boss

rib

Gear housing complete

Be sure to place the stepped edge on Handle (R) side.

Handle (R)

Heat sink

Handle (L)

Connector

Gear housing cover complete

P 13/13

stepped edge

Heat sink

FET

Light circuit