Avantone Pro Active MixCube Manuale - Pagina 2
Sfoglia online o scarica il pdf Manuale per Altoparlanti Avantone Pro Active MixCube. Avantone Pro Active MixCube 8. Powered mini-reference monitors
Stampa la paginaCabinet Design
Constructed of non-layered, high rigidity MDF board due to its natural low-resonance
characteristics. All cabinet edges are radiused.
Elegant Polyurethane high gloss "Butter-Cream" finish
7mm thick neoprene pad embedded into the base of the cabinet serves as a skid-resistant
acoustic isolator.
For creative mounting situations, we recessed an industry standard 5/8"-27 mic stand mount
into the base.
Driver Design
The paper cone, (chosen for its musical character) was custom designed utilizing the latest in FEA
modeling and "old-school" speaker design artistry. The finest New Zealand pulp material is blended
with mica fibers for rigidity and longevity.
The cloth surround material is made in Japan and has unique damping characteristics, enabling a
predictable compliance over the lifespan of the driver.
The motor structure is made of certified 1008 low carbon steel by Sumitomo. The magnets are Y-
40 GRADE (MIL-SPEC) yielding a 43oz. High-power/low-distortion motor structure.
Our proprietary 5.25" Die-cast aluminum frame supports the driver/cone minimizing mechanical
transfers.
The outer mounting face of the aluminum frame is polished for an elegant appearance.
Amplifier Design
We designed the amp module from the ground up to be a true professional-grade amplifier. It
incorporates "overkill" concepts in component selection as well as safety. The result is a "no-
compromise" amp with robust headroom characteristics that will rival the performance of much
higher priced studio rack mount amps.
REAR PANEL CONTROLS / CONNECTIONS
BALANCED INPUT:
as a 3-conductor BALANCED TRS ¼" or a 2 conductor UNBALANCED TS ¼" male plug. For
unbalanced operation with a TS connector the minus signal is automatically grounded.
SYSTEM GAIN:
input. Rotating the control clockwise increases the sensitivity while a counter-clockwise
rotation decreases sensitivity. The adjustable gain range is from -30 to +6 dB. A setting of +6
allows a full, unimpeded signal to be sent to the amplifier. The detented gain positions allow
for repeatable settings between speakers for proper matching. Please Note... when the signal
appearing at the input is too hot, the amplifier can overload causing distortion and possible
damage to the speaker. If overload occurs, attenuate (decrease) the input level by turning the
knob counter-clockwise a few clicks.
ON/OFF Switch:
still receiving power from the transformer however.
AC INPUT:
This input is only to be use with the proprietary AVANTONE Power Supply.
Tighten the cable/connector securely for reliable operation. Note: There is a switch on the
power supply for selecting the proper AC/MAINS operating voltage for your location.
GROUND LIFT Switch:
This can be used to aid in ground loop control of the incoming analog line signal.
This "combo XLR" input accepts a BALANCED male XLR plug as well
This variable control adjusts the sensitivity of the signal that appears at the
This illuminated switch turns the amplifier section on and off. The unit is
By engaging this switch the pin 1 shield is lifted at the input jack.