- ページ 2

スピーカー Avantone Pro Active MixCubeのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Avantone Pro Active MixCube 8 ページ。 Powered mini-reference monitors

ページを印刷する

Cabinet Design



Constructed of non-layered, high rigidity MDF board due to its natural low-resonance

characteristics. All cabinet edges are radiused.



Elegant Polyurethane high gloss "Butter-Cream" finish



7mm thick neoprene pad embedded into the base of the cabinet serves as a skid-resistant

acoustic isolator.



For creative mounting situations, we recessed an industry standard 5/8"-27 mic stand mount

into the base.

Driver Design

The paper cone, (chosen for its musical character) was custom designed utilizing the latest in FEA

modeling and "old-school" speaker design artistry. The finest New Zealand pulp material is blended

with mica fibers for rigidity and longevity.

The cloth surround material is made in Japan and has unique damping characteristics, enabling a

predictable compliance over the lifespan of the driver.

The motor structure is made of certified 1008 low carbon steel by Sumitomo. The magnets are Y-

40 GRADE (MIL-SPEC) yielding a 43oz. High-power/low-distortion motor structure.

Our proprietary 5.25" Die-cast aluminum frame supports the driver/cone minimizing mechanical

transfers.

The outer mounting face of the aluminum frame is polished for an elegant appearance.

Amplifier Design

We designed the amp module from the ground up to be a true professional-grade amplifier. It

incorporates "overkill" concepts in component selection as well as safety. The result is a "no-

compromise" amp with robust headroom characteristics that will rival the performance of much

higher priced studio rack mount amps.

REAR PANEL CONTROLS / CONNECTIONS



BALANCED INPUT:

as a 3-conductor BALANCED TRS ¼" or a 2 conductor UNBALANCED TS ¼" male plug. For

unbalanced operation with a TS connector the minus signal is automatically grounded.



SYSTEM GAIN:

input. Rotating the control clockwise increases the sensitivity while a counter-clockwise

rotation decreases sensitivity. The adjustable gain range is from -30 to +6 dB. A setting of +6

allows a full, unimpeded signal to be sent to the amplifier. The detented gain positions allow

for repeatable settings between speakers for proper matching. Please Note... when the signal

appearing at the input is too hot, the amplifier can overload causing distortion and possible

damage to the speaker. If overload occurs, attenuate (decrease) the input level by turning the

knob counter-clockwise a few clicks.



ON/OFF Switch:

still receiving power from the transformer however.



AC INPUT:

This input is only to be use with the proprietary AVANTONE Power Supply.

Tighten the cable/connector securely for reliable operation. Note: There is a switch on the

power supply for selecting the proper AC/MAINS operating voltage for your location.



GROUND LIFT Switch:

This can be used to aid in ground loop control of the incoming analog line signal.

This "combo XLR" input accepts a BALANCED male XLR plug as well

This variable control adjusts the sensitivity of the signal that appears at the

This illuminated switch turns the amplifier section on and off. The unit is

By engaging this switch the pin 1 shield is lifted at the input jack.