Jandy AquaLink RS6 Manuale di installazione - Pagina 8
Sfoglia online o scarica il pdf Manuale di installazione per Pannello di controllo Jandy AquaLink RS6. Jandy AquaLink RS6 16. Dual equipment systems
Stampa la pagina
- 1. Section 2. System Overview
- 2. Plumbing Diagrams
- 3. Connecting Power and Mounting Bezel
- 4. Connecting Control Panel Cable to Pcb
- 5. Section 3. Power Center Connection (Low Voltage)
- 6. Dip Switch Functions
- 7. Dip Switch Settings for Pool and Spa Combination
- 8. Section 5. Dual Equipment Wiring Diagram
Page 8
2.3
Plumbing Diagrams
2.3.1 Basic Plumbing
Refer to Figure 1 when plumbing two separate
sets of equipment. The basic setup consists of one
pump, filter and heater for the pool and another set
for the spa.
Pool Heater
Pool Return
Figure 1.
Basic Plumbing for Dual Equipment
2.3.2 Plumbing - Sharing One heater
When the system setup is using only one heater,
plumb the equipment as shown in Figure 2.
Please note that for this type of plumbing a new
bezel decal must be applied over the existing decal
in order to identify the correct labeling for the
HEATER and VALVE buttons.
RESET
AUTO
SERVICE
TIME OUT
Dual Equipment with
Shared Heater Bezel decal
4 3 2 1
4 3 2 1
S1
RESET
AUTO
SERVICE
TIME OUT
S2
Figure 2.
Dual Equipment System with One heater
Pool
Pump
Pool Filter
Check
Valve
(Optional)
Pool Intake
6 5 4 3 2 1
10 9 8 7 6 5 4 3 2 1
Spa Heater
Spa Return
NOTE When connecting to the AquaLink RS, plug
the JVAs into the Intake, Return and Cleaner
JVA sockets. Slide DIP Switch S1-6 to the
ON position. See wiring diagram in Section 4,
Figure 5.
From Solar
(if installed)
JVA
Shared Heater
Check
Valves
(4)
Return
Spa
Pump
Spa Filter
Check
Valve
(optional)
Spa Intake
To Solar
(if installed)
Pool Return
JVA
Pool Filter
JVA
Spa
Spa Filter
Pool
Pump
Pool
Intake
Spa
Pump
Spa
Intake