Lexmark Monochrome Laser Manuale di connessione - Pagina 5

Sfoglia online o scarica il pdf Manuale di connessione per Stampante Lexmark Monochrome Laser. Lexmark Monochrome Laser 19. Maintenance guide
Anche per Lexmark Monochrome Laser: Manuale d'uso (6 pagine), Scheda tecnica (1 pagine), Manuale supplementare (5 pagine), Eliminazione degli inceppamenti della carta (2 pagine), Manuale di eliminazione degli inceppamenti (2 pagine), Manuale di stampa (17 pagine), Aggiornamento (1 pagine), Manuale di connessione (5 pagine), Manuale informativo (1 pagine), Riferimento rapido (1 pagine), Manuale di manutenzione (11 pagine), Scheda di installazione (1 pagine), Manuale di manutenzione (10 pagine)

Storing media

Use the following guidelines for proper media storage. These help avoid media feeding problems and uneven print

quality:

• For best results, store media in an environment where the temperature is approximately 21°C (70°F) and

the relative humidity is 40%.

• Store cartons of media on a pallet or shelf, rather than directly on the floor.

• When storing individual packages of media out of the original carton, make sure they rest on a flat surface

so the edges do not buckle or curl.

• Do not place anything on top of the media packages.

The following hints can help avoid jams:

• Use only recommended paper or specialty media (referred to as media).

• Do not overload the media sources. Make sure the stack height does not exceed the maximum height

indicated by the load line labels in the sources.

• Do not load wrinkled, creased, damp, or curled media.

• Flex, fan, and straighten media before you load it.

• Do not use media that has been cut or trimmed by hand.

• Do not mix media sizes, weights, or types in the same media source.

• Make sure the recommended print side is face-up when loading all trays for simplex (single-sided) printing.

• Keep media stored in an acceptable environment. See "Storing media".

• Do not remove trays during a print job.

• Push all trays in firmly after loading them.

• Make sure the guides in the trays are properly positioned for the size of media loaded. Make sure the guides

are not placed too tightly against the stack of media.

• Make sure all cables that connect to the printer are correctly attached. See the Setup sheet for more

information.

• If a jam occurs, clear the entire media path. See the User's Guide for information on the media path.

Media guide

Page 2 of 2