Lexmark Monochrome Laser 연결 매뉴얼 - 페이지 5

{카테고리_이름} Lexmark Monochrome Laser에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark Monochrome Laser 19 페이지. Maintenance guide
Lexmark Monochrome Laser에 대해서도 마찬가지입니다: 사용자 설명서 (6 페이지), 사양 시트 (1 페이지), 보충 설명서 (5 페이지), 용지 걸림 제거 (2 페이지), 용지 걸림 지우기 매뉴얼 (2 페이지), 인쇄 매뉴얼 (17 페이지), 업데이트 (1 페이지), 연결 매뉴얼 (5 페이지), 정보 매뉴얼 (1 페이지), 빠른 참조 (1 페이지), 유지 관리 매뉴얼 (11 페이지), 설치 시트 (1 페이지), 유지 관리 매뉴얼 (10 페이지)

Storing media

Use the following guidelines for proper media storage. These help avoid media feeding problems and uneven print

quality:

• For best results, store media in an environment where the temperature is approximately 21°C (70°F) and

the relative humidity is 40%.

• Store cartons of media on a pallet or shelf, rather than directly on the floor.

• When storing individual packages of media out of the original carton, make sure they rest on a flat surface

so the edges do not buckle or curl.

• Do not place anything on top of the media packages.

The following hints can help avoid jams:

• Use only recommended paper or specialty media (referred to as media).

• Do not overload the media sources. Make sure the stack height does not exceed the maximum height

indicated by the load line labels in the sources.

• Do not load wrinkled, creased, damp, or curled media.

• Flex, fan, and straighten media before you load it.

• Do not use media that has been cut or trimmed by hand.

• Do not mix media sizes, weights, or types in the same media source.

• Make sure the recommended print side is face-up when loading all trays for simplex (single-sided) printing.

• Keep media stored in an acceptable environment. See "Storing media".

• Do not remove trays during a print job.

• Push all trays in firmly after loading them.

• Make sure the guides in the trays are properly positioned for the size of media loaded. Make sure the guides

are not placed too tightly against the stack of media.

• Make sure all cables that connect to the printer are correctly attached. See the Setup sheet for more

information.

• If a jam occurs, clear the entire media path. See the User's Guide for information on the media path.

Media guide

Page 2 of 2