Ceyear 6481 Series Manuale rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale rapido per Utensile elettrico Ceyear 6481 Series. Ceyear 6481 Series 6. Optical fiber fusion splicer
Stampa la paginaFusion Operation
Preparation of Fiber
1. First fit the fiber into the heat-shrink
tube.
2. Strip off the fiber and make sure that
the coating residue on the stripped
fiber has been removed.
3. Clean the fiber with anhydrous
ethanol at a concentration of 99% or
more.
4. Cut the fiber at the correct cutting
length.
Fusion fiber
1. Place the fiber on the fusion splicer
and make sure that the fiber is on the
bottom of V-groove and the fiber end
is placed between the edge of
V-groove and the center of electrode.
2. Check the fusion and heating modes.
In case of the fusion for the standard
single-mode fiber (ITU-T G.652),
"SM-SM" mode shall be selected.
3. Close the windshield and start fusion.
4. Observe the fusion process through
the monitor.
Heat-shrink protection
1. Take out the finished fiber.
2. Place the heat-shrink tube at the
middle of heater and move the fiber so
that the fusion point is at the center of
heat-shrink tube.
3. Close the heater cover and start
heating.
4. After heat shrink is completed, take out
the heat-shrink tube. If the heat-shrink
effect is poor, the heating time may be
modified accordingly (in the heating
mode menu).
Coated fiber
Bare fiber
涂覆光纤
裸光纤
10-16mm
V型槽边缘
V-groove edge
Φ80-150um
Electrode
电极中心
center