A&L Furniture Poly Istruzioni per il montaggio
Sfoglia online o scarica il pdf Istruzioni per il montaggio per Arredamento per esterni A&L Furniture Poly. A&L Furniture Poly 2. 44” square walk-in table
Stampa la paginaAssembly Instructions for Poly 44" Square Walk-In Table
Tools Needed:
Power Drill or Screwdriver
#2 Square Drive Bit
Lay the table tops upside down. Place the 36" aluminum strips along the outside crosspieces on the top &
place the 24" aluminum strips along the center crosspieces centering them lengthwise. Attach with the ¾"
screws, 6 screws in the 36" piece & 4 screws in the 24" piece. (See photo 1.) Now attach the small poly
blocks on the end of the leg slots. Attach with 2 - 1½" screws in each block. (See photo 2.)
Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2½" screws
in the predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See
photo 3.)
Predrilled
holes in leg
supports
belong at
Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place
upside down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2½" screws
on each side (See photos 4 and 5)
Hardware:
64 - 2½" Screws
4 - 1½" Screws
20 - ¾" Screws
2 - 36" Aluminum Strips
2 - 24" Aluminum Strips
2 - Small Poly Blocks
this end
photo 3
Parts List:
Table Top—2 pieces
Table Leg Assemblies—2 pieces
Bench Tops - 4 pieces
1"x5½"x14½" Bench Leg Supports—8 pieces
1"x5½"32" Bench Bottoms—4pieces
Step 1
photo 1
Step 2
photo 4
Step 3
*Keep 2x2 even with leg supports*
photo 2
photo 5