屋外用家具 A&L Furniture PolyのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。A&L Furniture Poly 2 ページ。 44” square walk-in table

Assembly Instructions for Poly 44" Square Walk-In Table

Tools Needed:

Power Drill or Screwdriver

#2 Square Drive Bit

Lay the table tops upside down. Place the 36" aluminum strips along the outside crosspieces on the top &

place the 24" aluminum strips along the center crosspieces centering them lengthwise. Attach with the ¾"

screws, 6 screws in the 36" piece & 4 screws in the 24" piece. (See photo 1.) Now attach the small poly

blocks on the end of the leg slots. Attach with 2 - 1½" screws in each block. (See photo 2.)

Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2½" screws

in the predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See

photo 3.)

Predrilled

holes in leg

supports

belong at

Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place

upside down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2½" screws

on each side (See photos 4 and 5)

Hardware:

64 - 2½" Screws

4 - 1½" Screws

20 - ¾" Screws

2 - 36" Aluminum Strips

2 - 24" Aluminum Strips

2 - Small Poly Blocks

this end

photo 3

Parts List:

Table Top—2 pieces

Table Leg Assemblies—2 pieces

Bench Tops - 4 pieces

1"x5½"x14½" Bench Leg Supports—8 pieces

1"x5½"32" Bench Bottoms—4pieces

Step 1

photo 1

Step 2

photo 4

Step 3

*Keep 2x2 even with leg supports*

photo 2

photo 5