Garmin Reactor 40 Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Attrezzatura marina Garmin Reactor 40. Garmin Reactor 40 25. Mechanical
Anche per Garmin Reactor 40: Manuale di istruzioni per l'installazione (11 pagine), Manuale di istruzioni per l'installazione (13 pagine), Manuale di istruzioni per l'installazione (29 pagine), Manuale di configurazione (8 pagine)

Component Layout

Single-Helm Layout

NOTE: This diagram is for planning purposes only. If needed, specific connection diagrams are included in the

detailed installation instructions for each component.

Hydraulic connections are not shown in this diagram.

Item Description

Helm control

Pump

ECU

12 to 24 Vdc

battery

CCU

NMEA 2000

network

Important Considerations

A dedicated helm control is not included in all autopilot packages. If you install the

autopilot without a dedicated helm control, the autopilot CCU must be connected to

the same NMEA 2000 network as a compatible Garmin chartplotter to configure and

control the autopilot system.

You must connect the ECU to a 12 to 24 Vdc power source. To extend this cable, use

the correct wire gauge

(Power Cable Extensions,

You must connect the NMEA 2000 power cable to a 9 to 16 Vdc power source.

You can mount the CCU in a non-submerged location near the center of the boat, in

any orientation

(CCU Mounting and Connection Considerations,

Mount the CCU away from sources of magnetic interference.

You must connect the helm control or compatible Garmin chartplotter and the CCU

to a NMEA 2000 network using the included T-connectors

Considerations,

page 8).

If there is not an existing NMEA 2000 network on your boat, you can build one using

the supplied cables and connectors

Autopilot System,

page 17).

page 12).

(NMEA 2000 Connection

(Building a Basic NMEA 2000 Network for the

page 7).