Garmin Reactor 40 Manuale di istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Attrezzatura marina Garmin Reactor 40. Garmin Reactor 40 25. Mechanical
Anche per Garmin Reactor 40: Manuale di istruzioni per l'installazione (11 pagine), Manuale di istruzioni per l'installazione (13 pagine), Manuale di istruzioni per l'installazione (29 pagine), Manuale di configurazione (8 pagine)
Stampa la pagina
Item Description
Helm control
(or compatible
Garmin chart
plotter)
NMEA 2000
power cable
NMEA 2000
network
ECU
CCU
ECU power cable
CCU cable
Pump
Alarm
Shadow Drive
sensor (optional)
Autopilot switch
(not included)
4
Important Considerations
A dedicated helm control is not included in all autopilot packages. If you install the
autopilot without a dedicated helm control, the autopilot CCU must be connected
to the same NMEA 2000
and control the autopilot system.
You should install this cable only if you are building a NMEA 2000 network. Do not
install this cable if there is an existing NMEA 2000 network on your boat.
You must connect the NMEA 2000 power cable to a 9 to 16 Vdc power source.
You must connect the helm control or compatible Garmin chartplotter and the CCU
to a NMEA 2000 network using the included T-connectors
Considerations,
page 8).
If there is not an existing NMEA 2000 network on your boat, you can build one using
the supplied cables and connectors
Autopilot System,
page 17).
The ECU must be located within 0.5 m (19 in.) of the pump.
The cables connecting the ECU to the pump cannot be extended.
You can mount the CCU in a non-submerged location near the center of the boat, in
any orientation
(CCU Mounting and Connection Considerations,
Mount the CCU away from sources of magnetic interference.
You must connect the ECU to a 12 to 24 Vdc power source. To extend this cable, use
the correct wire gauge
(Power Cable Extensions,
To extend this cable to reach the ECU, you may need to use cable extensions (sold
separately)
(CCU Mounting and Connection Considerations,
You must connect this cable to the alarm and the Shadow Drive
The pump must be located within 0.5 m (19 in.) of the ECU.
The cables connecting the pump to the ECU cannot be extended.
The alarm provides audible alerts from the autopilot system, and you should install it
near the primary helm station
You must install the Shadow Drive sensor properly in the hydraulic steering line, and
connect it to the CCU cable
If your autopilot package does not include a Shadow Drive sensor, you should install
a manual Single Pole Single Throw (SPST) switch (not included) to disable the
autopilot if necessary.
network as a compatible Garmin chartplotter to configure
®
(Building a Basic NMEA 2000 Network for the
page 12).
(Installing the Alarm,
(Installing the Shadow Drive Sensor,
(NMEA 2000 Connection
page 7).
page 7).
sensor.
™
page 16).
page 16).