2N Lift8 Manuale breve - Pagina 9

Sfoglia online o scarica il pdf Manuale breve per Sistema interfonico 2N Lift8. 2N Lift8 14. Io module
Anche per 2N Lift8: Manuale breve (8 pagine), Manuale breve (12 pagine), Manuale breve (13 pagine), Manuale breve (6 pagine), Manuale breve (12 pagine), Manuale breve (17 pagine)

Warning

Maintain the connection polarity to make the 2N



Safety

The bus is electrically isolated from the telephone line circuits according to the



EN60950 requirements and its low voltage cannot cause any electrical

accident.

Mode switch

Set the camera module connection mode with a 10-position switch 0–9:

0 - the camera module works within the 2N

CU/splitter via a 2-wire bus);

1 - the camera module works autonomously (see below for details);

2-9 - no setting (the red ERR LED is flashing).

IP camera connection

Connect the camera to the IP CAM Ethernet connector. The integrated DHCP server will

set IP address 10.0.0.1 to the camera.

Interconnect the IP camera with the camera module using an Ethernet cable.

Warning

Interconnect the camera module only with the IP camera only via the Ethernet



cable. No other connection is supported.

RS-232/RS-485 Camera Connection

Connect the camera to the SERIAL CAM connector using a push-on terminal board.

See the table below for connector details.

+5V

+UCC

Use the 2N® Lift8 Service Tool application to set the camera type and other

parameters.

TX/D

data transmitted

data received

Lift8 system work correctly.

Lift8 system (connected to the

RX/D+

GND

signal ground