2N Lift8 간단한 매뉴얼 - 페이지 9

{카테고리_이름} 2N Lift8에 대한 간단한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2N Lift8 14 페이지. Io module
2N Lift8에 대해서도 마찬가지입니다: 간단한 매뉴얼 (8 페이지), 간단한 매뉴얼 (12 페이지), 간단한 매뉴얼 (13 페이지), 간단한 매뉴얼 (6 페이지), 간단한 매뉴얼 (12 페이지), 간단한 매뉴얼 (17 페이지)

Warning

Maintain the connection polarity to make the 2N



Safety

The bus is electrically isolated from the telephone line circuits according to the



EN60950 requirements and its low voltage cannot cause any electrical

accident.

Mode switch

Set the camera module connection mode with a 10-position switch 0–9:

0 - the camera module works within the 2N

CU/splitter via a 2-wire bus);

1 - the camera module works autonomously (see below for details);

2-9 - no setting (the red ERR LED is flashing).

IP camera connection

Connect the camera to the IP CAM Ethernet connector. The integrated DHCP server will

set IP address 10.0.0.1 to the camera.

Interconnect the IP camera with the camera module using an Ethernet cable.

Warning

Interconnect the camera module only with the IP camera only via the Ethernet



cable. No other connection is supported.

RS-232/RS-485 Camera Connection

Connect the camera to the SERIAL CAM connector using a push-on terminal board.

See the table below for connector details.

+5V

+UCC

Use the 2N® Lift8 Service Tool application to set the camera type and other

parameters.

TX/D

data transmitted

data received

Lift8 system work correctly.

Lift8 system (connected to the

RX/D+

GND

signal ground