2N Lift8 간단한 매뉴얼 - 페이지 11
{카테고리_이름} 2N Lift8에 대한 간단한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2N Lift8 14 페이지. Io module
2N Lift8에 대해서도 마찬가지입니다: 간단한 매뉴얼 (8 페이지), 간단한 매뉴얼 (12 페이지), 간단한 매뉴얼 (13 페이지), 간단한 매뉴얼 (6 페이지), 간단한 매뉴얼 (12 페이지), 간단한 매뉴얼 (17 페이지)
페이지 인쇄
Autonomous Camera Module Connection
The camera module can be used autonomously without being connected to 2N® Lift8.
To make the module work autonomously, change the connection mode to autonomous (no
2N® Lift8 connection) using a rotary switch (switch to 1), connect a local power supply,
insert a microSD card and make basic configuration.
Find the basic settings in the camera.cfg file on the microSD card. If you enter a new
microSD card, this file will be created automatically. Modify the configuration file slightly
according to the camera type used.
Example: 1,2,50,10.0.0.1/jpg/image.jpg,1,3600 (refer to the table below for details).
Caution
You are recommended to format the microSD card before inserting it in the
camera module (FAT32).
Parameter
name
Camera type
Resolution
Compression ratio
Camera URL IP
10.0.0.1/jpg/image.jpg
Snapshot interval
Record limit/file
[1h]
Caution – IP camera
Set resolution and compression ratio directly in the IP camera configuration.
Camera URL IP is different for each IP camera.
Example
Value
range
1
1-3
2
1-3
50
10%-100%
1
1s-3600s
3600
3600s-
86400s
Default
value
1
1=RS-232
2=RS-485
3=IP camera
1
1=160x80
2=320x240
3=640x480
50%
image compression
1s
camera recording interval
3600s
microSD card file creation
interval
Note
10