Brother QL-1110NWB Manuale di configurazione rapida - Pagina 4
Sfoglia online o scarica il pdf Manuale di configurazione rapida per Etichettatrice Brother QL-1110NWB. Brother QL-1110NWB 9.
Anche per Brother QL-1110NWB: Manuale di configurazione rapida (9 pagine), Manuale (2 pagine)
Stampa la pagina
4.
Thread the DK Roll through the Label Printer.
• Align the edge of the DK Roll with the upright edge of the
Label Output Slot.
• Check that the DK Roll is threaded straight so that the
labels will not be skewed.
• Push the first label through the Label Output Slot until the
end comes out of the Slot as shown.
NOTE
If you have difficulty inserting the first label, try inserting
from the side under the sensor (1).
5.
Close the DK Roll Compartment Cover.
IMPORTANT
IMPORTANT
• Do not leave any printed labels in the Label Printer. Doing so will cause the labels to jam.
• When not in use, remove any DK Rolls from inside the Label Printer and close the DK Roll Compartment Cover to
prevent dust and debris from accumulating in the Label Printer.
5. Turn Power On/Off
On: Press the Power ( ) Button to turn the Label Printer On. The Status LED turns green.
IMPORTANT
IMPORTANT
Press the Feed ( ) Button to align the end of the DK Roll.
Off: Press and hold the Power ( ) Button again to turn the Label Printer Off.
IMPORTANT
IMPORTANT
When turning the Label Printer Off, do not disconnect the AC Power Cord until the orange Status LED turns Off.
1