1.3 Operator panel
The operator panel is located on the right side of the
scanner. The panel consists of a Function Number Dis-
play, four buttons and a LED.
.
Name
Function Number
Display
Buttons
Function
Send to
Scan
Power button
LED
-
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and "fi-5530C2 Oper-
ator's Guide" on the Setup CD-ROM.
2
Function No.
display
Function
Send to
Scan
Power button
LED
Function
Indicates the state of the scan-
ner. The meaning of the num-
bers and alphabets indicated
are explained later in this sec-
tion.
Changes the Function activated
by the [Send to] button (*).
Launches the linked applica-
tion software (*).
Turns the scanner ON and
OFF.
Lights when the scanner is
turned ON.
■ Indications on the Function
Number Display
The following shows the indications on the Function
Number Display.
Indication
Lights only one time upon turning on the
8
scanner.
Indicates that the scanner has been turned
P
ON and is being initialized.
Indicates that initialization will soon be
0
completed.
Indicates that initialization has been com-
1
pleted successfully.
This status is called "Ready Status."
Indicates that a temporary error (that users
U
can solve) has occurred during the initial-
ization or scanning of documents.
[U] and an error number (1, 2, 6) are dis-
played alternately.
To return the scanner to the ready status
([1]), press the [Scan] or [Send to] button
while the error is indicated.
Indicates that a device alarm (that users can
E
not solve) has occurred during the initial-
ization or scanning of documents.
[E] and an alarm number (2 to 9, and, c, d,
F) are indicated alternately.
To return the scanner to the ready status
([1]), press the [Scan] or [Send to] button.
If this alarm occurs, turn the power off and
then on again. If the alarm is indicated after
turning on the power again, contact your
servic engineer.
Meaning
Stampa la pagina