AEG ABE682F1NF Manuale d'uso - Pagina 14
Sfoglia online o scarica il pdf Manuale d'uso per Congelatore AEG ABE682F1NF. AEG ABE682F1NF 20.
Stampa la pagina
14
www.aeg.com
Problem
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature.
Door is misaligned or inter-
feres with ventilation grill.
Door does not open easily.
There is too much frost and
ice.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The compressor starts after a
period of time.
The appliance is not level-
led.
You attempted to re-open
the door immediately after
closing.
The door is not closed cor-
rectly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The "Frostmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
Solution
This is normal, no error has
occurred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of
the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet-
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off "Frostmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frost-
matic function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.