AEG ABE682F1NF 사용자 설명서 - 페이지 14
{카테고리_이름} AEG ABE682F1NF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ABE682F1NF 20 페이지.
페이지 인쇄
14
www.aeg.com
Problem
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature.
Door is misaligned or inter-
feres with ventilation grill.
Door does not open easily.
There is too much frost and
ice.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The compressor starts after a
period of time.
The appliance is not level-
led.
You attempted to re-open
the door immediately after
closing.
The door is not closed cor-
rectly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The "Frostmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
Solution
This is normal, no error has
occurred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of
the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet-
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off "Frostmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frost-
matic function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.