AEG Competence 6292D-M Istruzioni per l'uso e l'installazione - Pagina 5

Sfoglia online o scarica il pdf Istruzioni per l'uso e l'installazione per Cappa di ventilazione AEG Competence 6292D-M. AEG Competence 6292D-M 18.

Before proceeding with the assembly operations, remove the anti-grease

filter(s) (Fig.11) so that the unit is easier to handle.

In the case of assembly of the appliance in the venting version prepare the

hole for evacuation of the air.

Hood assembly

Remove the structure from the packaging and separate the upper part from

the lower part.

Refer to Fig.2 and ensure that the arrow is positioned on the same side as

the appliance controls. Make 4, Ø8 holes in the ceiling and drive in 3 screws

without completely tightening them.

Do not insert the screw into the hole marked with an X on the hole template

(the screws and expansion plugs must be suitable for the type of wall).

Take the upper part of the structure B and insert the 3 slots onto the 3

screws that are not completely tightened. (Fig3)

Rotate slightly to fit.

Drive in the fourth screw X and tighten the remaining 3 to allow definitive

blocking of the upper part of structure B.

Take the lower part of the telescopic structure C and insert it into the upper

structure B.

Adjust the height (Fig.5) by referring to the amounts indicated in and block

it using the 8 unit screws G that are supplied (Fig.4)

Venting version

Fix the flexible pipe to the prepared air evacuation hole (Fig.6)

Take the upper chimney piece and fix it with 4 unit screws G. (Fig.7)

Take the lower chimney and fix it with 2 unit screws G, drive in hood to

avoid it down (Fig.8)

Insert the venting unit inside the structure and set in 4 mounting hole, drive

in 4 unit screw N (Fig.9)