Kohler Composed K-EX20257T-NWS3-CP Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Apparecchiature per il bagno Kohler Composed K-EX20257T-NWS3-CP. Kohler Composed K-EX20257T-NWS3-CP 14. Desk-mount sensor faucet

Stampa la pagina

2.如图所示,将电源线,龙头感应器线

及电磁阀线与相应的接线端相连

接。然后整理好线束并锁紧控制盒

盖。

Solenoid wire connector

注：①为交流电源出线口，使用时，

将①的卡扣（薄片状）去除，保证

出线口光滑。

②为龙头感应器出线口。

三如何安装排水组件

旋下排水器盘片(19)，在其底面沿

周围涂上一圈密封油灰。把排水本

体(20)由底下插入面盆。

把排水器盘片(19)旋入排水本体

(20)。从下方用手拧紧锁紧螺母

(21)，去除多余的油灰。

注意：在锁紧螺母(21)拧紧后，不

可再调整排水本体的位置，否则将

会破坏油灰密封。

把尾管(22)接上存水弯(23)，尾管

需插入存水弯25mm到55mm之间。

1495648-T2-A

电磁阀接线端

电源线接线端

Power wire connector

Apply plumbers putty

涂油灰

2.Cabing and tidying wires such as

power wire assembly,senor wires

assembly and solenoid wire assembly

to right position. Then lock the control

box.

龙头感应线接线端

Sensor wire connector

Note: ① is the outlet of AC power supply.

Remove the clip (lamellar) during the

process of use to ensure the smoothing

of outlet.

② is the outlet of faucet sensor.

How to Install the Drain

Screw off the drain flange (19) from drain.

Apply a ring of plumbers putty around

underside of the drain flange (19). Insert

the drain body (20) into the lavatory from

the underside.

Thread the drain flange (19) onto the drain

Body (20). Tighten the locknut (21) by hand

from the underside of the fixture. Remove

any excess putty.

Note:

Do not try to change the position of

the drain after the locknut (21) is tightened,

or you may break the putty seal.

Connect the tailpiece (22) to the trap (23).

The tailpiece should extend 25mm to

55mm into the trap.