Kohler Composed K-EX20257T-NWS3-CP Manuale di istruzioni per l'installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Apparecchiature per il bagno Kohler Composed K-EX20257T-NWS3-CP. Kohler Composed K-EX20257T-NWS3-CP 14. Desk-mount sensor faucet

Stampa la pagina

安装结果检查

检查并确保所有衔接处都已拧紧，打开排水系统

和主要供水源，检查并修理有漏水的接口。

清理说明

适用于所有加工处理过的表面，以中性肥皂水清

洗镀层表面，再以干净的软布彻底擦干整个表面。

许多清洁剂，比如氨水，去污粉及洁厕灵等，会

对电镀表面造成伤害，切忌使用。

有腐蚀性的清洁剂或溶剂不可使用于科勒的水龙

头及其配件上。

用户须知

1. 感应指示灯的各种闪烁情况

感应指示灯是使用者了解感应龙头有效、

唯一的途径。所以明白了感应指示灯闪烁

所代表的含义，可以正确使用感应龙头，

如图示:

(1) 快速闪烁，代表感应龙头正处于通电后

的30秒自动调节阶段。期间，安装者、使

用者不得干扰其自动调节，感应范围内不

要放置物体。

(2) 间隔6秒钟闪烁一次（直流版本），表

示电池即将使用完，请更换电池。

(3) 间隔2秒钟连续闪烁：若直流感应龙

头，代表龙头电池耗尽，已停止工作，等

待使用者更换电池；若交流感应龙头，表

示为两种情况：一种为刚刚停电；另一种

为在交流供电正常的情况下，则电源盒直

流接线端接触不良。

(4) 在正常工作情况下，当有物体被感应

时，龙头出水，感应指示灯闪烁一次。

（龙头关闭，感应指示灯不闪烁。）

2. 超时出水控制

连续在感应状态下使用约一分钟，龙头自动止水。

自动止水后，手或物体离开感应范围后，再次进

入感应范围内，龙头正常工作，否则无反应。

1495648-T2-A

INSTALLATION CHECKOUT

Check and ensure that all connections are tight. Open the

drain. Turn on main water supply and check for leaks.

Replace as required.

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with a mild soap and warm

water. Wipe entire surface completely dry with a clean soft

cloth. Many cleaners may contain chemicals, such as

ammonia, chlorine, toilet cleaner etc. which could adversely

affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets

and fittings.

IMPORTANT CONSUMER INFORMATION

1. Note of the Indicator Flashing

The indicator is the only and effective way to

learn the faucet's working conditions. So the

users can use the sensor faucet correctly with

knowing the meaning of the sensor indicator's

flashing.

(1) Fast flashing means the faucet is in the period

指示灯

of adjusting sensing distance after power on for

Indicator Light

30s. During these 30s, please do not put objects

in the sensing range.

(2) The indicator flashes every 6 seconds (DC

type) indicates that the unit is out of battery and

has stopped working. Replease batteries.

(3) The indicator flashes every 2s: as for DC type

faucets, this indicates the unit is out of battery and

ceases working. Please replace batteries. For AC

faucet, it indicates two possibilities: one is that the

unit is out of battery; or poor DC terminal contact

under normal AC power supply.

(4) In normal condition, the water will flow and the

indicator will flash one time when objects are

inducted. (The indicator does not flash when

faucet stops flowing.)

2. Overtime Flowing Control

When the faucet works for about 1 minute continuously, the

water will be shut off automatically. After that, objects must

be removed from the sensing range. Then the water will

flow when objects go into the sensing range again.

Otherwise, the faucet will not work.