Kohler Symbio K-1335-H Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Apparecchiature per il bagno Kohler Symbio K-1335-H. Kohler Symbio K-1335-H 32. Bath whirlpool

Stampa la pagina
Corner Post

8. Secure the Bench or End Panel

- Tighten the bench or end panel bolts and hex nuts which are loosely assembled to the corner post.
9. Secure the Nailing-in Flanges and Install the Optional Apron Frame
- Drill a small pilot hole through the side nailing in flange at each stud. Add shims between the side nailing in
flange and the studs as needed to eliminate gaps.
- Nail 1/4" (6mm) thick furring strips to the side studs to shim out to the edge of the nailing in flange.
- Use #6 large head galvanized nails to secure the side nailing in flange to the studs.
- Repeat these steps for the receptor/bench or end panel.
- Install the optional apron frame according to the instructions packed with the apron.

10. Secure the Corner Post Adjustment Bracket

- Securely tighten the corner post adjustment bracket nuts.

11. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
- Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
- Install the faucet valving according to the faucet manufacturer's instructions. Do not install the faucet trim until
instructed. Open the hot and cold water supplies, and check the supply connections for leakage.
- Run water into the whirlpool, and check the drain connections for leakage.
Kohler Co.
Back Side Of
Bench Or Side
Panel
Tighten
the hex
nuts
Corner Post
Adjustment
Bracket
Nuts
Nail 1/4"
(6mm) thick
furring strips
to the side
studs
Stud
Use #6 large-head
galvanized nails to
secure the side
nailing-in flange to
the studs
7
Drill small holes
through the side
nailing-in flange
8" (20.3cm) apart
A
1012312-2-