- ページ 7

バスルーム設備 Kohler Symbio K-1335-HのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler Symbio K-1335-H 32 ページ。 Bath whirlpool

Corner Post

8. Secure the Bench or End Panel

- Tighten the bench or end panel bolts and hex nuts which are loosely assembled to the corner post.

9. Secure the Nailing-in Flanges and Install the Optional Apron Frame

- Drill a small pilot hole through the side nailing in flange at each stud. Add shims between the side nailing in

flange and the studs as needed to eliminate gaps.

- Nail 1/4" (6mm) thick furring strips to the side studs to shim out to the edge of the nailing in flange.

- Use #6 large head galvanized nails to secure the side nailing in flange to the studs.

- Repeat these steps for the receptor/bench or end panel.

- Install the optional apron frame according to the instructions packed with the apron.

- Securely tighten the corner post adjustment bracket nuts.

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.

- Connect the drain to the trap according to the drain manufacturer's instructions.

NOTICE: An access panel will simplify future maintenance.

- Install the faucet valving according to the faucet manufacturer's instructions. Do not install the faucet trim until

instructed. Open the hot and cold water supplies, and check the supply connections for leakage.

- Run water into the whirlpool, and check the drain connections for leakage.

Kohler Co.

Back Side Of

Bench Or Side

Panel

Tighten

the hex

nuts

Corner Post

Adjustment

Bracket

Nuts

Nail 1/4"

(6mm) thick

furring strips

to the side

studs

Stud

Use #6 large-head

galvanized nails to

secure the side

nailing-in flange to

the studs

Drill small holes

through the side

nailing-in flange

8" (20.3cm) apart

1012312-2-