Kohler Englefield VALENCIA Manuale di istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Arredamento per interni Kohler Englefield VALENCIA. Kohler Englefield VALENCIA 7. Double drawer vanity
Anche per Kohler Englefield VALENCIA: Manuale di istruzioni per l'installazione (7 pagine)
Stampa la pagina
®
VALENCIA
/ VALENCIA ELITE
( c) For 7 7 29 6 A - * :
To make the installation easier remove the
cabinet door. To release the door hinges press
the buttons at the rear of the hinges.
Button
2 Changing drawer trims (Optional)
NOTE : This section is only applicable if you
have purchased alternate trim for your vanity
cabinet.
( a) After the drawer has been removed (refer
to section 1 ) , unscrew the trim fixing screws
from each angle bracket located behind either
side of the trim.
Angle
brackets
( b) Unscrew the 3 - 4 screws from underneath
the trim and remove the trim from the cabinet.
NOTE : Keep the screws for use later on.
(C) Fix the new trim in place using the screws
that were removed from the original trim.
1278274-A02-D September 2023
®
Single Drawer Vanity
3. Water supply and waste pipe holes
Hook
Trim
Angle
brackets
Page4
INSTALLATION INSTRUCTIONS
( a) Measure and mark the centres for water
supply and waste pipes on the back of the
cabinet.
NOTE : Ensure that plumbing holes are
positioned to allow for a maximum height of
260 mm between the bottom of the basin to
the base of the trap.
Maximum
height
260mm
( b) With a suitably sized hole saw, drill the
holes for the water supply and waste.
( c) Having drilled the required holes fit the
cabinet into position over the pipework.
NOTE: Before fastening the cabinet make
sure that it is sitting level and square.
englefield.co.nz