Aqua Logic DSHP-4-WCMD Manuale di installazione e manutenzione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione e manutenzione per Pompa di calore Aqua Logic DSHP-4-WCMD. Aqua Logic DSHP-4-WCMD 9.

WARNING: DO NOT over tighten water fittings.

•

Mount Heat Pump on a flat pad and away for water spray.

•

Give at least 1 ft all the way around unit for servicing.

•

Install evaporator water inlet and outlet.

•

Install condenser water inlet and outlet.

•

Test water fittings for leaks.

•

Apply electrical power to the Heat Pump.

•

Adjust the controller to the desired water temperature. (See "Operation and Programming")

•

Important:

Regulate condenser water until pressure on the pressure gauge reads between 115 to 125 PSIG for models

DSHP-4-WCMD thru DSHP-9-WCMD and 195 to 220 PSIG for model DSHP-10-WCMD. Check after 15 minutes of run

time, adjust the water flow (if needed) to the correct pressure.

Warning: This unit must have proper water flow rate both on the evaporator and

the condenser to operate correctly.

HEAT PUMP SET-UP AJUSTMENTS