DFE STEADYWEB 6 Manuale di avvio rapido - Pagina 4

Sfoglia online o scarica il pdf Manuale di avvio rapido per Controllore DFE STEADYWEB 6. DFE STEADYWEB 6 12. Tension controller
Anche per DFE STEADYWEB 6: Manuale di istruzioni per l'uso (20 pagine)

Stampa la pagina

enclosure is fastened to the mounting surface you have chosen by

two M4 (#8) screws. Install the screws on the mounting surface.

Leave the screws loose about 6 turns. Position the keyholes in the

back panel of the enclosure over the screws and slide it down until

it locks in place. The cover must be open to tighten the mounting

screws and secure the enclosure in place.

Version P Only

The pneumatic enclosure should be located in the area of your

clutch or brake. Drill and tap four M3 (#4) holes in a rectangle. The

enclosure is fastened to the mounting surface you have chosen by

four M3 (#4) screws. The pneumatic servo is sensitive to any

mounting off it's vertical axis. Mounting off vertical axis can cause

error in output pressure.

Version V Only

The High Voltage Output module, required for 45 VDC and 90

VDC only, should be located in the area of your clutch or brake. If

you are using the DIN Rail Clip (DRC) option, the V-Out module

may simply be clipped to a DIN rail. If you are using the Enclosure

mount style without the DRC option, drill and tap two M4 (#8)

holes to match the screw hole dimensions on the back surface of

the V-Out enclosure. The enclosure is fastened to the mounting

surface you have chosen by two M4 (#8) screws. Install the

screws on the mounting surface. Leave the screws loose about 6

turns. Position the keyholes in the back panel of the enclosure

over the screws and slide it down until it locks in place. The cover

must be open to tighten the mounting screws and secure the

enclosure in place. This module is not sensitive to mounting at any

angle.