AVS Electronics VECTOR Plus Manuale di installazione - Pagina 9
Sfoglia online o scarica il pdf Manuale di installazione per Sistema di sicurezza AVS Electronics VECTOR Plus. AVS Electronics VECTOR Plus 12. Bidirectional gsm interface
Example:
Name: "1"
Number: 138
Nome: "2"
Numero: 12
Parameters programming (SMS by command)
It is possible to send SMS messages stored into the SIM card using a standard touchtone
telephone set connected to terminals Ac - Bc. If the PSTN line is present, to send SMS
messages "by command", it is necessary to close to negative by a few seconds the terminal
"GSM" of the unit, to force it into GSM mode. In contrast, if the PSTN line is not available,
VECTOR Plus is supposed to be already operating in GSM mode.
Sending an SMS message "by command" is like dialling a normal telephone number. The
sequence of DTMF digits to be sent is the following: 0000nnTT, where;
0000: is a prefix that informs VECTOR Plus that the sequence is not a normal telephone call but
an SMS message request.
and were configured with DIP3 in ON position, which causes elimination of the first digit of the number
when calling through GSM, IT IS NOT NECESSARY TO ADD A"0" digit to the prefix to activate SMS
function. The prefix must always be 0000)
nn: is the number corresponding to the SMS message that has to be sent, and depends on the
order messages were stored into the SIM card when programmed. Remember that, as explained
before in this document, the first three SMS messages are used for specific technical
communications and their content shall be wrote according to their function, however, if some of
this technical messages are not required, they can be filled up with a different text to be sent "by
command" when needed.
TT: is the position into the SIM card phonebook of the telephone number to which the SMS
message has to be sent. Like for the text messages, the position of telephone numbers also
depends on the order they were stored into the SIM card when programmed. Issuing "99" as the
value of TT, the selected SMS message will be sent to all telephone numbers
in the SIM card phonebook.
Example 1:
Dialling: 00000712
VECTOR Plus will send the SMS message stored in position 7 of the SIM card to the telephone
number stored in position 12 of the internal phonebook.
Example 2:
Dialling: 00000599
VECTOR Plus will send the SMS message stored in position 5 of the SIM card to all telephone
numbers in the phonebook.
NOTE 1: to enable sending an SMS by command when VECTOR Plus is not operating in GSM mode, simply
shortcircuit to negative for a few seconds the "GSM" terminal of the equipment, while dialling the DTMF
sequence for SMS activation. Once the SMS message has been sent, the operation will return to normal
mode and successive telephone calls will go on over PSTN line.
NOTE 2: after issuing the SMS activation sequence, the dialling equipment must wait the initiation of SMS
sending procedure, indicated by a "shifting line" in the display (see Display indications chapter), before
releasing the simulated line at Ac - Bc terminals, otherwise, the SMS procedure is aborted.
SMS 1 "PSTN line fault" is enabled. - (1)
SMS 2 "PSTN line restore" is disabled.
SMS 3 "Autotest" is enabled. - (3)
The technical SMS messages enabled will be sent to all telephone
numbers stored into the SIM card phonebook - (8)
Autotest SMS will be sent every 12 hours. - (12)
(NOTE: although VECTOR Plus were connected through an internal PABX
9
contained
(max. 50)