AVS Electronics VECTOR Plus Installation Manual - Page 9

Browse online or download pdf Installation Manual for Security System AVS Electronics VECTOR Plus. AVS Electronics VECTOR Plus 12 pages. Bidirectional gsm interface

Print Page

Example:

Name: "1"

Number: 138

Nome: "2"

Numero: 12

Parameters programming (SMS by command)

It is possible to send SMS messages stored into the SIM card using a standard touchtone

telephone set connected to terminals Ac - Bc. If the PSTN line is present, to send SMS

messages "by command", it is necessary to close to negative by a few seconds the terminal

"GSM" of the unit, to force it into GSM mode. In contrast, if the PSTN line is not available,

VECTOR Plus is supposed to be already operating in GSM mode.

Sending an SMS message "by command" is like dialling a normal telephone number. The

sequence of DTMF digits to be sent is the following: 0000nnTT, where;

0000: is a prefix that informs VECTOR Plus that the sequence is not a normal telephone call but

an SMS message request.

and were configured with DIP3 in ON position, which causes elimination of the first digit of the number

when calling through GSM, IT IS NOT NECESSARY TO ADD A"0" digit to the prefix to activate SMS

function. The prefix must always be 0000)

nn: is the number corresponding to the SMS message that has to be sent, and depends on the

order messages were stored into the SIM card when programmed. Remember that, as explained

before in this document, the first three SMS messages are used for specific technical

communications and their content shall be wrote according to their function, however, if some of

this technical messages are not required, they can be filled up with a different text to be sent "by

command" when needed.

TT: is the position into the SIM card phonebook of the telephone number to which the SMS

message has to be sent. Like for the text messages, the position of telephone numbers also

depends on the order they were stored into the SIM card when programmed. Issuing "99" as the

value of TT, the selected SMS message will be sent to all telephone numbers

in the SIM card phonebook.

Example 1:

Dialling: 00000712

VECTOR Plus will send the SMS message stored in position 7 of the SIM card to the telephone

number stored in position 12 of the internal phonebook.

Example 2:

Dialling: 00000599

VECTOR Plus will send the SMS message stored in position 5 of the SIM card to all telephone

numbers in the phonebook.

NOTE 1: to enable sending an SMS by command when VECTOR Plus is not operating in GSM mode, simply

shortcircuit to negative for a few seconds the "GSM" terminal of the equipment, while dialling the DTMF

sequence for SMS activation. Once the SMS message has been sent, the operation will return to normal

mode and successive telephone calls will go on over PSTN line.

NOTE 2: after issuing the SMS activation sequence, the dialling equipment must wait the initiation of SMS

sending procedure, indicated by a "shifting line" in the display (see Display indications chapter), before

releasing the simulated line at Ac - Bc terminals, otherwise, the SMS procedure is aborted.

SMS 1 "PSTN line fault" is enabled. - (1)

SMS 2 "PSTN line restore" is disabled.

SMS 3 "Autotest" is enabled. - (3)

The technical SMS messages enabled will be sent to all telephone

numbers stored into the SIM card phonebook - (8)

Autotest SMS will be sent every 12 hours. - (12)

(NOTE: although VECTOR Plus were connected through an internal PABX

contained

(max. 50)