Dell Inspiron 600m Manuale di servizio - Pagina 36

Sfoglia online o scarica il pdf Manuale di servizio per Computer portatile Dell Inspiron 600m. Dell Inspiron 600m 40. Hard drive
Anche per Dell Inspiron 600m: Inizia qui (2 pagine), Inizia qui (2 pagine), Inizia qui (2 pagine), Manuale introduttivo (2 pagine), Manuale d'uso (34 pagine), Manuale di configurazione (2 pagine), Come iniziare (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di configurazione (2 pagine), Manuale di servizio (41 pagine), Manuale d'uso della Media Base (26 pagine), Manuale di servizio (41 pagine), Installazione e configurazione (38 pagine), Avvio rapido (2 pagine), Avvio rapido (2 pagine), Avvio rapido (2 pagine), Impostazione del computer (2 pagine), Manuale di servizio (41 pagine), Manuale di servizio (4 pagine)

Dell Inspiron 600m Manuale di servizio
1 M2 x 5-mm modem screws
(2)
2 modem
3 modem cable connector
4 system board connector
 
9. Connect the modem cable to the modem.
NOTICE:
The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.
 
10. Align the modem with the screw hole and press the modem into the connector on the system board.
 
11. Install the two M2 x 5-mm screws to secure the modem to the system board.
 
12. Replace the cover.
 Adding a Mini PCI Card
If you ordered a Mini PCI card with your computer, the card is already installed.
 
CAUTION:
Before performing any of the procedures listed below, read and follow the safety instructions in the Product  Information Guide.
NOTICE:
Read
"Before Working Inside Your
 
1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.
 
2. Save and close any open files, exit any open programs, and
 
3. Disconnect the computer from the electrical outlet.
 
4. Wait 10 to 20 seconds and then disconnect any attached devices.
 
5. Remove the battery, any installed PC Card or blanks, and devices.
NOTICE:
Handle modules and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the back of
the computer. Continue to ground yourself periodically during this procedure.
 
6. Turn the computer over.
 
7. Loosen the two captive screws on the cover, and remove the cover.
Computer" before performing the following procedure.
shut down the
computer.