Dell Inspiron 600m Service Manual - Page 36

Browse online or download pdf Service Manual for Laptop Dell Inspiron 600m. Dell Inspiron 600m 40 pages. Hard drive
Also for Dell Inspiron 600m: Start Here (2 pages), Start Here (2 pages), Start Here (2 pages), Getting Started Manual (2 pages), User Manual (34 pages), Setup Manual (2 pages), Getting Started (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Setup Manual (2 pages), Service Manual (41 pages), Media Base User's Manual (26 pages), Service Manual (41 pages), Installing And Configuring (38 pages), Quick Start (2 pages), Quick Start (2 pages), Quick Start (2 pages), Setting Up Your Computer (2 pages), Service Manual (41 pages), Service Manual (4 pages)

Print Page

1 M2 x 5-mm modem screws

(2)

2 modem

3 modem cable connector

4 system board connector

9. Connect the modem cable to the modem.

NOTICE:

The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.

10. Align the modem with the screw hole and press the modem into the connector on the system board.

11. Install the two M2 x 5-mm screws to secure the modem to the system board.

12. Replace the cover.

Adding a Mini PCI Card

If you ordered a Mini PCI card with your computer, the card is already installed.

CAUTION:

Before performing any of the procedures listed below, read and follow the safety instructions in the Product Information Guide.

NOTICE:

Read

"Before Working Inside Your

1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.

2. Save and close any open files, exit any open programs, and

3. Disconnect the computer from the electrical outlet.

4. Wait 10 to 20 seconds and then disconnect any attached devices.

5. Remove the battery, any installed PC Card or blanks, and devices.

NOTICE:

Handle modules and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the back of

the computer. Continue to ground yourself periodically during this procedure.

6. Turn the computer over.

7. Loosen the two captive screws on the cover, and remove the cover.

Computer" before performing the following procedure.

shut down the

computer.