DH Lifelabs AquaSolvo AAHE-50WC04 Manuale di istruzioni - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per Apparecchiature di laboratorio DH Lifelabs AquaSolvo AAHE-50WC04. DH Lifelabs AquaSolvo AAHE-50WC04 10. Eco ambient air sterilizer
Anche per DH Lifelabs AquaSolvo AAHE-50WC04: Manuale di istruzioni (10 pagine)
Stampa la pagina
Troubleshooting
Symptom
Probable Cause/Solution
Sterilizer does not
Power cord not securely plugged into outlet. Make sure plug
operate.
is securely inserted.
No AC power. Check fuse or circuit breaker. Replace fuse with
a time delay type or reset the circuit breaker.
Sterilizer is starting to
make noise and the air
4-in-1 HEPA filter may be dirty or obstructed. Replace filter.
output is low.
HOCl generator is dirty or has contaminated water in it.
Discard any water that is in the generator and thoroughly
Air coming from
clean it, then refill with clean fresh water and non-iodized salt.
Sterilizer has a bad
NOTE: The first time you use the Sterilizer, you might perceive
odor.
a plastic or paint smell. This is normal, but it should disappear
quickly. If the smell persists or if you sense a burning smell,
please disconnect the unit and contact Customer Assistance.
Air quality does
Windows or doors are open. Constant introduction of dirty
not improve as the
air from outside the room can reduce the effectiveness of the
Sterilizer operates.
Sterilizer. Close all exterior doors and windows.
Water added to Sterilizer
Check that HOCl generator is properly seated in the Sterilizer.
but Water Level indicator
If it still does work after several trial with HOCl generator
still flashing.
seated in place, pls contact Customer Assistance.
It takes some time to dissolve the salt and monitor the actual
Salt Level indicator
concentration. If it still does not work after some time, discard
displayed even after salt
salt water solution and mix a new batch per the instruction
has been added.
carefully.
Salt Level indicator
Make sure amount of salt added is correct. If necessary discard
flashing after salt has
salt water solution and mix a new batch per the instruction
been added.
carefully.
Ensure that there are no obstacles near the appliance and that
The appliance is very
it has a minimum of 12 inches (30 cm) of clearance around it for
loud.
optimal operation.
The app does not
operate properly or it is
not possible to sync the
Contact Customer Assistance.
Sterilzer with the AiLivin
smartphone app.
13
FCC Statement
Supplier's Declaration of Comformity:
Trade Name: DH Lifelabs
Models: AAHE-50WC04C / AAHE-50WC04 / AAHE-50WC04C
Responsible Party: Dernier & Hamlyn Inc.
Address: Dernier & Hamlyn Inc., 720 Northgate Parkway, Wheeling, IL 60090
Telephone Number: 1-877-548-9722
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Caution: The user is cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate
the equipment. Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Copyright © 2022 Dernier & Hamlyn Inc. All rights reserved. Revised 2022/09/29
14