Dell PowerEdge 2800 Conversione Manualline - Pagina 9

Sfoglia online o scarica il pdf Conversione Manualline per Server Dell PowerEdge 2800. Dell PowerEdge 2800 36. Poweredge 2800 server
Anche per Dell PowerEdge 2800: Aggiornamento delle informazioni (24 pagine), Manuale di installazione (22 pagine), Manuale (44 pagine), Installazione dell'hardware (14 pagine), Riferimento rapido (2 pagine), Specifiche tecniche (2 pagine)

Y1001bk0.book Page 7 Thursday, July 8, 2004 4:32 PM

Important Safety Information

Observe the safety precautions in the following subsections when installing your system in the rack.

CAUTION:

You must strictly follow the procedures in this document to protect yourself as well as

others who may be involved. Your system may be very large and heavy, and proper preparation and

planning are important to prevent injury to yourself and to others. This becomes increasingly important

when systems are installed high up in the rack.

Rack Stabilizer Feet

CAUTION:

Installing systems in a rack without the front and side stabilizer feet installed could cause

the rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore,

always install the stabilizer feet before installing components in the rack.

CAUTION:

After installing systems in a rack, never pull more than one system out of the rack on its

slide assemblies at one time. The weight of more than one extended system could cause the rack to tip

over and cause injury.

The stabilizer feet help prevent the rack from tipping over when a system or other component is

pulled out of the rack with the slide assemblies fully extended. See the documentation provided

with the rack cabinet for instructions on installing and anchoring the stabilizer feet.

Installing the Tower-to-Rack Kit

CAUTION:

The system may weigh up to 49 kilograms (108 pounds) when fully loaded. To prevent

personal injury, do not attempt to move the system by yourself.

The tower-to-rack kit includes the following items (see Figure 1-1):

•

One rack front panel with rack handles and thumbscrews

•

Twenty-two 6-32 x 0.312-inch black flat-head Torx screws

•

One rack bezel, complete with keylock, keys, and attaching hardware

•

Six 10-32 shoulder nuts

•

Rack control panel carrier assembly kit

Tower-to-Rack and Rack-to-Tower Conversion Guide