Dell Force10 S4810P Manuale di avvio rapido - Pagina 23

Sfoglia online o scarica il pdf Manuale di avvio rapido per Interruttore Dell Force10 S4810P. Dell Force10 S4810P 27. Quick start guide

Step Task

Configure an interface

as untagged. This

command is available

only in VLAN

interfaces.

Assign an IP address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs

to communicate, you must assign an IP address to the VLANs to route traffic

between the two interfaces. The shutdown command in INTERFACE mode

does not affect Layer 2 traffic on the interface.

NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,

is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default

vlan-id vlan-id command.

Task

Configure an IP address

and mask on the interface.

Connecting the S4810 to the Network

Once you have completed the hardware installation and software configuration

for the S4810, you can connect to your company network by following your

company's cabling requirements.

Command Syntax

untagged interface

Command Syntax

ip address ip-address mask

[secondary]

Command Mode

INTERFACE

Command Mode

INTERFACE

Installing the Software