3 Day Blinds MINI BLINDS Classic Manuale di avvio rapido - Pagina 4

Sfoglia online o scarica il pdf Manuale di avvio rapido per Tende per finestre 3 Day Blinds MINI BLINDS Classic. 3 Day Blinds MINI BLINDS Classic 6.

Stampa la pagina

BLIND INSTALLATION

• If you have not already done so unwrap the cellophane

from around the blind stack. Caution: DO NOT cut the

cellophane as the cords or ladders supporting the blind may

be inadvertently cut.

TOP MOUNT BLIND INSTALLATION

Side View

Top View Open

Top View Closed

END MOUNT BLIND INSTALLATION

• While supporting the bottom of the blind, unwind the draw

cords and gently lower the blind to its full length. (See

"Operating the Blind".)

NOTE: If the bracket interferes with any of the working parts,

the incorrect holes of the end mount bracket may have been

selected.

| Classic Mini Blinds

• If you ordered the blind

with a valance, snap the

valance clips to the front

of the headrail before

installing the blind. The

valance clips should be

spaced equidistant from

the end brackets and each

other to allow proper

support for the entire

valance. Make sure that

the Valance Clips do not

interfere with any moving

parts. You will install the

valance slat after the blind

is in place.

• Be sure the hinged doors

on the brackets are in the

open position.

• Slide the headrail into the

mounting brackets until

the front of the bracket

hooks under the inside

front part of the headrail.

• Close the hinged doors on

the brackets.

• Be sure the hinged end

brackets are in the open

position.

• Hook the front edge of

the headrail onto the lip

of the center support

bracket(s), if applicable.

Insert the headrail into the

end brackets, making sure

that no cords or slats are

in the way.

• Close the hinges on the

end brackets until you

hear them "snap."

VALANCE INSTALLATION

Make sure the valance clips have been attached to the

headrail as noted in "Blind Installation".

INSIDE MOUNT VALANCE INSTALLATION

1. Insert the top of the

valance into the top lip of

the valance clips.

2. Gently lift the top lip

of the valance clip and

snap the middle into the

center lip of the valance

clips. (See Figure A)

OUTSIDE MOUNT VALANCE INSTALLATION

NOTE: The outside Contempo Valance requires the return

ends to be formed into position. To do this:

Make Sure the slats are evenly spaced inside the valance.

On the back of the valance, locate the notches

approximately 4" in from each end. If extension brackets

are used, the notch will be further from the end.

At the notch, bend the return at one end of the valance

all the way over to crease (See Figure B1) and then back

halfway to form a 90° angle. (See Figure B2)

Repeat for the other end of the valance.

Install the valance per the "Inside Mount Vlance

Instructions" provided above.

Figure A