3 Day Blinds MINI BLINDS Classic Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Tende per finestre 3 Day Blinds MINI BLINDS Classic. 3 Day Blinds MINI BLINDS Classic 6.

Stampa la pagina

INSIDE MOUNT

INSIDE MOUNT WITH END BRACKETS

• Mount a bracket in each corner of the window.

| Classic Mini Blinds

• With the blind fully

opened, hold it up to wall

in the position it will hang.

Make sure the blind is

centered left and right and

the height is correct. Make

sure the blind is level.

• Make pencil marks 1/4"

past each end of the

headrail.

• Place each mounting

bracket in a level position

on the pencil marks with

the large hole facing the

floor.

• Mount each bracket with

two screws.

• Position the front edge

of the closed end bracket

flush with the front edge

of the window casing to

mark the screw holes.

• To open the latch of the

end bracket use a flathead

screwdriver as shown.

• Mount each bracket with

two screws.

TO INSTALL CENTER SUPPORT BRACKET(S):

Proceed to "Blind Installation".

• If your hardware packet

includes one center

support bracket, position

it as close to the center

of the window casing as

possible, making sure

that it will not interfere

with any moving parts.

If more than one center

support bracket has been

provided, position them

equidistant from the end

brackets and each other,

again avoiding all moving

parts.

• Align the back of the

center support bracket

with the back end of the

mounting bracket. The

alignment is crucial for

proper blind installation.

• Using a pencil, mark the

window casing through

the holes in the top of the

center support bracket.

For maximum stability, the

pencil marks should be

made in the two holes at

the front of the bracket.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each pencil

mark.

• Mount the bracket

using two of the screws

provided.

• Repeat this procedure

for any remaining center

support brackets.