3 Day Blinds MINI BLINDS Classic Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Оконные жалюзи 3 Day Blinds MINI BLINDS Classic. 3 Day Blinds MINI BLINDS Classic 6 страниц.
Печатать страницуINSIDE MOUNT
INSIDE MOUNT WITH END BRACKETS
• Mount a bracket in each corner of the window.
2
| Classic Mini Blinds
• With the blind fully
opened, hold it up to wall
in the position it will hang.
Make sure the blind is
centered left and right and
the height is correct. Make
sure the blind is level.
• Make pencil marks 1/4"
past each end of the
headrail.
• Place each mounting
bracket in a level position
on the pencil marks with
the large hole facing the
floor.
• Mount each bracket with
two screws.
• Position the front edge
of the closed end bracket
flush with the front edge
of the window casing to
mark the screw holes.
• To open the latch of the
end bracket use a flathead
screwdriver as shown.
• Mount each bracket with
two screws.
TO INSTALL CENTER SUPPORT BRACKET(S):
Proceed to "Blind Installation".
• If your hardware packet
includes one center
support bracket, position
it as close to the center
of the window casing as
possible, making sure
that it will not interfere
with any moving parts.
If more than one center
support bracket has been
provided, position them
equidistant from the end
brackets and each other,
again avoiding all moving
parts.
• Align the back of the
center support bracket
with the back end of the
mounting bracket. The
alignment is crucial for
proper blind installation.
• Using a pencil, mark the
window casing through
the holes in the top of the
center support bracket.
For maximum stability, the
pencil marks should be
made in the two holes at
the front of the bracket.
• Using a drill with a
/
" drill
1
16
bit or an awl, make a small
pilot hole at each pencil
mark.
• Mount the bracket
using two of the screws
provided.
• Repeat this procedure
for any remaining center
support brackets.