3 Day Blinds ROLLER SHADE Come iniziare

Sfoglia online o scarica il pdf Come iniziare per Tende per finestre 3 Day Blinds ROLLER SHADE. 3 Day Blinds ROLLER SHADE 8. Continuous cord loop and link system with cassette, continuous cord loop with side channels

Stampa la pagina
ROLLER SHADE
Continuous Cord Loop and Link System
with Cassette
Continuous Cord Loop with Side Channels
GETTING STARTED
A few simple tools are required:
Steel Tape Measure
Power Drill and
Flathead & Phillips
Drill Bits
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
STANDARD HARDWARE
Inside Mount Cassette with
Outside Mount Cassette with
Predrilled Hole Locations
Predrilled Hole Locations
OPTIONAL HARDWARE
Extension Bracket
Hold Down Bracket
1
| Cassettes and Side Channels
Pencil
Level
(for outside mount)
Awl (or tool for
Screwdriver
starting a screw hole)
Tension Pulley and
Bracket with Screws
Spacers
CASSETTE INFORMATION
The cassettes you received with your product are REQUIRED
for proper installation. Screws should be installed at each
end and any additional screws will need to be evenly spaced
between the two end predrilled holes.
SCREW PLACEMENT
2"
Space Evenly
NOTE: Measure and mark all predrilled locations
before installing.
• Measure 2" in from the ends of the headrail and mark
the holes location on the mounting surface.
• Space additional screws evenly between the end holes.
• Adjust the cassette projection to accommodate
obstructions to the bottom rail, such as window cranks or
handles, using the spacer blocks provided.
• Before installing the cassette directly to the sill or wall you
must fi rst remove the fascia and the shade from the cassette.
• To remove the fascia, push down on the face of the fascia
and pull the inner edge shown and swing out to disengage
from the end plate on each side.
• Next remove the shade from the cassette by retracting the pin
on the idle side using the dial and turning it counter-clockwise,
then pull the shade away from the control side bracket.
Space Evenly
2"