3 Day Blinds VINYL BLINDS Come iniziare - Pagina 5

Sfoglia online o scarica il pdf Come iniziare per Tende per finestre 3 Day Blinds VINYL BLINDS. 3 Day Blinds VINYL BLINDS 10.

Stampa la pagina
VALANCE INSTALLATION
INSIDE MOUNT
Make sure the valance clips have been attached to the
headrail. (See "Blind Installation")
5
| Vinyl Blinds
• To install your two slat
valance, start with the
shortest of the two slats.
This slat will be installed
on the lower section of
the valance clips.
• Place the top edge of the
valance slat into the top
edge of the valance clips.
Push the valance upward
until the bottom edge of
the valance snaps into the
valance clips.
• Place the top edge of the
valance slat into the top
edge of the valance clips.
Push the valance upward
until the bottom edge of
the valance snaps into the
valance clips.
OUTSIDE MOUNT
NOTE: With your blind you have received a two piece valance
with valance returns. You have also received enough valance
clips for your size blind. As you can see, one of the valance
slats is shorter than the other.
Before installing the valance, make sure that all of the
Regular Valance Clips have been attached to the front of the
headrail. Also, install a Button Valance Clip on each end of the
mounting brackets. (See "Blind Installation")
WARNING: Large scissors are recommended. Do not use a
straight edge knife or any other cutting implement. Keep
fingers and other objects out of the way when cutting.
• Each of the valance slats
have 4" returns. Using
a steel tape measure,
determine the length
required for your specific
installation by measuring
from the mounting
surface to the front of the
headrail. For the longes".
For the shortest valance
slat add
/
". For example,
3
8
if the measurement from
the mounting surface to
the front of the headrail is
3", the valance slat returns
on the longest valance slat
returns would be trimmed
to 3
/
" and the shortest
5
8
valance would be trimmed
to 3
/
". Mark each of
3
8
these measurements on
the corresponding valance
returns using a pencil.
• Using large scissors, cut
the valance returns to the
proper length.
• To install your two slat
valance, start with the
shortest of the two slats.
This slat will be installed
on the lower section of
the valance clips.