Dell S4048-ON Manuale di configurazione - Pagina 28

Sfoglia online o scarica il pdf Manuale di configurazione per Interruttore Dell S4048-ON. Dell S4048-ON 30. Enterprise switches
Anche per Dell S4048-ON: Manuale di configurazione (19 pagine), Manuale di risoluzione dei problemi (29 pagine)

Switch configuration (OS 10.x)

3.3.4

Remove DCB policies and apply standard flow control on port-channel

member ports

OS10(config)# interface range ethernet 1/1/49,1/1/50

OS10(conf-range-eth1/1/49,1/1/50)# no priority-flow-control

OS10(conf-range-eth1/1/49,1/1/50)# no ets

OS10(conf-range-eth1/1/49,1/1/50)# no qos-map traffic-class

OS10(conf-range-eth1/1/49,1/1/50)# no service-policy output type queuing

<queuing-policy-name>

OS10(conf-range-eth1/1/49,1/1/50)# no service-policy input type network-qos

<policy-map-name>

OS10(conf-range-eth1/1/49,1/1/50)# flowcontrol receive on

OS10(conf-range-eth1/1/49,1/1/50)# flowcontrol transmit off

OS10(conf-range-eth1/1/49,1/1/50)# exit

OS10(config)#

OS10(config)# interface port-channel 1

OS10(conf-if-po-1)# no switchport trunk allowed vlan <vlan-id>

OS10(conf-if-po-1)# switchport access vlan 1

OS10(conf-if-po-1)# exit

OS10(config)#

3.3.5

Once DCB is disabled on the switch, the PS Series arrays will no longer use the VLAN ID that was configured

when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid VLAN must

be configured for all host servers, switches, and PS Series array members. A valid VLAN can use the default

or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example, VLAN 100). If a non-

default VLAN is configured, then any ports connected to the arrays must be configured as untagged.

The previous steps in section 3.3.3 and 3.3.4, revert the switch ports to default native vlan 1. Use the

following command to remove VLANs other than vlan 1 from the switch configuration.

OS10(config)# no interface vlan <vlan-id>

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026