EarthWay 2170T Manuale di montaggio e istruzioni per l'uso
Sfoglia online o scarica il pdf Manuale di montaggio e istruzioni per l'uso per Spreader EarthWay 2170T. EarthWay 2170T 6. Commercial tow
broadcast spreader
Anche per EarthWay 2170T: Manuale di montaggio e istruzioni per l'uso (6 pagine)
Stampa la pagina
2170T C
ommerCial
B
roadCasT
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, EMAIL: [email protected]
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the word "FRONT" on the gear box points toward the tow bar of the
spreader. The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise.
Clean the impeller surface after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pulled at three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader
thoroughly after each use. Coat all metal surfaces (inside & outside of chassis) with light oil or silicon spray to help
prevent corrosion. Wash between the shut-off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
33117
32100
Qty 1
Qty 2
36210
Qty 2
36214
31100
Qty 4
*31114
Qty 7
12152
12148
Qty 2
Qty 2
*Included in Extension Kit
1. Remove and identify all loose parts from carton
1/4-20 SS Locknut
(Qty 4 #36214)
1/4-20 X 1½"
Phillips Panhead
T
ow
s
preader
READ THE DIRECTIONS BEFORE ASSEMBLY
36300
32103
Qty 6
Qty 9
36105
Qty 1
33109
Qty 1
31120
Qty 1
Qty 2
31106
Qty 3
.
(Qty 4 #36300)
2. Position hopper on side. Install frame using (4) 1/4-20 x 1½" Pan Head Phillips
machine screws and (4) 1/4-20 nylon insert locknuts. First put bolts through holes in
frame then through the holes in bottom of hopper. Secure with locknuts. TIGHTEN
THESE LOCKNUTS NOW......TIP: coat stainless steel bolts with wax or grease
before tightening to prevent them from seizing.
DO NOT TIGHTEN WITH POWER TOOLS.
ROCK SALT and POWDERED MATERIALS
should not be used in this spreader as it will damage
33108
Qty 1
the gearbox and can void the warranty.
Use only granular materials.
30
Do not tow
OVER
faster than
3 MPH
3 MPH
12
22
13
18
15
14
28
10
7-2013 Pt# 52165
9
21
6
7
MADE IN THE USA
PAGE 1