Configuring a 1010 VoIP Module:
The IMG 1010 has slots for two 1010 VoIP modules. When configuring the 1010 VoIP Modules, the
module in position 0 is displayed in ClientView as 'VoIP Module 0'. When adding a second 1010 VoIP
Module to the 1010 Motherboard the module will be displayed in ClientView as 'VoIP Module 1'. In
ClientView, the existing 1010 VoIP Module in slot 0 should already be configured and the Network
Interfaces object would have already been created. Follow the steps below to configure the 1010
VoIP Module being added.
Configure Network Interface: (IMG 1010 only)
1. Before starting the configuration expand the network interfaces. It should look something like the
screen capture below. In the screen capture below, VoIP module 0 refers to the VoIP module in
position 0.
2. Right-click on the Network Interfaces object and select New Network Interface. The Network
interface pane will appear as shown in screen capture below. Click in the Physical Interface field
select Module:1 Port 0 from the drop down menu. VoIP Module 1: Port 0 is the VoIP Module being
added to the IMG 1010.
3. Once VoIP Module 1 has been selected, the rest of the fields can be filled in. Below is information
on each of the fields.
Logical Interface - If VoIP Module 0 or 1 is selected the Logical Interface will default to
Redundant Data. The VoIP Modules use the Data ports on the rear of the IMG 1010 for IP
Communications.
Address Type - Only IPV4 is supported on IMG 1010
IP Address - Click in the IP address field and an "Enter IP address" box appears. Enter the IP
address that will be given the VoIP Module just added.
Subnet - Click in the IP address field and an "Enter IP address" box appears. Enter the Subnet
Mask that will be given the VoIP Module just added.
Default Gateway -
Enter the IP Address of the Default Gateway this interface will be connected to. (This is not a
Media Gateway it is a Network Gateway)
Gratuitous ARP and ARP Responses - This field is used for the SIP-Based Load Balancing
feature when creating a SIP Virtual Address. When a Virtual SIP Address is created set this field
to Disable. When the Gratuitous ARP and ARP Responses is set to Disable the Virtual IP Address
will not be allowed to issue a Gratuitous ARP.
Dialogic Corporation
Click in the Default Gateway field and an "Enter IP address" box appears.
Part # 07-8740-02
Page 7 of 9
Stampa la pagina