- ページ 7

ゲートウェイ Dialogic IMG 1010のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Dialogic IMG 1010 9 ページ。 Connecting dc power
Dialogic IMG 1010 にも：取付説明書 (6 ページ), クイック・スタート・マニュアル (11 ページ), クイック・スタート・マニュアル (18 ページ), クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (4 ページ)

Configuring a 1010 VoIP Module:

The IMG 1010 has slots for two 1010 VoIP modules. When configuring the 1010 VoIP Modules, the

module in position 0 is displayed in ClientView as 'VoIP Module 0'. When adding a second 1010 VoIP

Module to the 1010 Motherboard the module will be displayed in ClientView as 'VoIP Module 1'. In

ClientView, the existing 1010 VoIP Module in slot 0 should already be configured and the Network

Interfaces object would have already been created. Follow the steps below to configure the 1010

VoIP Module being added.

1. Before starting the configuration expand the network interfaces. It should look something like the

screen capture below. In the screen capture below, VoIP module 0 refers to the VoIP module in

position 0.

2. Right-click on the Network Interfaces object and select New Network Interface. The Network

interface pane will appear as shown in screen capture below. Click in the Physical Interface field

select Module:1 Port 0 from the drop down menu. VoIP Module 1: Port 0 is the VoIP Module being

added to the IMG 1010.

3. Once VoIP Module 1 has been selected, the rest of the fields can be filled in. Below is information

on each of the fields.

Logical Interface - If VoIP Module 0 or 1 is selected the Logical Interface will default to

Redundant Data. The VoIP Modules use the Data ports on the rear of the IMG 1010 for IP

Communications.

Address Type - Only IPV4 is supported on IMG 1010

IP Address - Click in the IP address field and an "Enter IP address" box appears. Enter the IP

address that will be given the VoIP Module just added.

Subnet - Click in the IP address field and an "Enter IP address" box appears. Enter the Subnet

Mask that will be given the VoIP Module just added.

Default Gateway -

Enter the IP Address of the Default Gateway this interface will be connected to. (This is not a

Media Gateway it is a Network Gateway)

Gratuitous ARP and ARP Responses - This field is used for the SIP-Based Load Balancing

feature when creating a SIP Virtual Address. When a Virtual SIP Address is created set this field

to Disable. When the Gratuitous ARP and ARP Responses is set to Disable the Virtual IP Address

will not be allowed to issue a Gratuitous ARP.

Dialogic Corporation

Click in the Default Gateway field and an "Enter IP address" box appears.

Part # 07-8740-02

Page 7 of 9