Miller ArcStation Manuale d'uso - Pagina 15
Sfoglia online o scarica il pdf Manuale d'uso per Accessori per la saldatura Miller ArcStation. Miller ArcStation 20.
Anche per Miller ArcStation: Manuale d'uso (44 pagine)
Stampa la pagina
3-10. 60S And 60SX Weld Curtain
Tools Needed:
9/16 in.
hex bit 5/16 in.
4
HH
5
HH
1
4
EE or OO
2
3
EE or OO
6
6
1
Corner Post
.
When securing corner post to
table, bolt from back side of
table.
Remove the two rear tube caps. In-
sert corner post into each rear tube
and use the supplied two bolts FF to
secure corner posts.
2
Left Curtain Rail
3
Right Curtain Rail
.
Be sure that curtain snaps face
to the outside on curtain rails.
Slide left and right curtain rail over
each corner post. Start the supplied
four bolts KK into rings on each
curtain rail.
4
Rear Top Rail (2)
5
Rail Connector
Assemble the two rear top rails
together with the rail connector and
secure with four bolts HH, two in
from the bottom and two in from the
front.
Slide rear top rail over each corner
post and use the supplied two bolts
KK to secure top rail.
6
Rear Bottom Rail (2)
Remove grounding lug.
Use the supplied bolt EE and three
bolts OO and install rear bottom
rails to table top.
Use supplied nut ZZ to re-install
grounding lug to bolt EE.
Snap left, right, and rear weld cur-
tain to curtain rails.
Adjust side curtains to desired
angle and tighten bolts KK in rings.
NOTICE − Do not touch or place hot
parts against curtains to prevent
burning holes through curtains.
OM-247318 Page 11