Miller Spoolmatic 30A Manuale d'uso - Pagina 19

Sfoglia online o scarica il pdf Manuale d'uso per Accessori per la saldatura Miller Spoolmatic 30A. Miller Spoolmatic 30A 36. Welding guns
Anche per Miller Spoolmatic 30A: Manuale d'uso (32 pagine), Manuale d'uso (32 pagine)

Stampa la pagina
Miller Spoolmatic 30A Manuale d'uso

7-1. Replacing Canister Inlet Guide

3
Tools Needed:

7-2. Replacing Spool Canister

4
3
Tools Needed:
1
2
8
1
2
7
6
5
4
5
1
Top Cover
2
Pressure Arm Lever
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew
5
Canister Cover
Loosen thumbscrew and remove
cover.
6
Wire Spool
7
Spool Brake Thumbnut
Loosen thumbnut, retract wire onto
spool, secure, and remove spool.
8
Canister Inlet Guide
Turn counterclockwise to remove.
Install new guide.
Reinstall spool and thread welding
wire (see Section 5-4).
Close pressure arm lever. Adjust
spool brake pressure and drive roll
pressure if necessary.
Reinstall covers.
Ref. T0051-B / T0052-B
1
Top Cover
2
Pressure Arm Lever
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew (Canister
Rotation)
Turn thumbscrew counterclock-
wise three full turns.
5
Spool Canister
Remove as shown. Push new can-
ister into wire drive housing until ful-
ly seated. Tighten thumbscrew.
Install spool and thread welding
wire (see Section 5-4).
Close pressure arm lever. Adjust
spool brake pressure and drive roll
pressure as necessary.
Reinstall covers.
Ref. T0051-B
OM-264 713 Page 15