Miller Spoolmatic 30A Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller Spoolmatic 30A. Miller Spoolmatic 30A 36 pagina's. Welding guns
Ook voor Miller Spoolmatic 30A: Gebruikershandleiding (32 pagina's), Gebruikershandleiding (32 pagina's)
Pagina afdrukken
7-1. Replacing Canister Inlet Guide
3
Tools Needed:
7-2. Replacing Spool Canister
4
3
Tools Needed:
1
2
8
1
2
7
6
5
4
5
1
Top Cover
2
Pressure Arm Lever
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew
5
Canister Cover
Loosen thumbscrew and remove
cover.
6
Wire Spool
7
Spool Brake Thumbnut
Loosen thumbnut, retract wire onto
spool, secure, and remove spool.
8
Canister Inlet Guide
Turn counterclockwise to remove.
Install new guide.
Reinstall spool and thread welding
wire (see Section 5-4).
Close pressure arm lever. Adjust
spool brake pressure and drive roll
pressure if necessary.
Reinstall covers.
Ref. T0051-B / T0052-B
1
Top Cover
2
Pressure Arm Lever
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew (Canister
Rotation)
Turn thumbscrew counterclock-
wise three full turns.
5
Spool Canister
Remove as shown. Push new can-
ister into wire drive housing until ful-
ly seated. Tighten thumbscrew.
Install spool and thread welding
wire (see Section 5-4).
Close pressure arm lever. Adjust
spool brake pressure and drive roll
pressure as necessary.
Reinstall covers.
Ref. T0051-B
OM-264 713 Page 15