Miller 1025 Manuale dell'operatore - Pagina 6

Sfoglia online o scarica il pdf Manuale dell'operatore per Camera Accessories Miller 1025. Miller 1025 13. Fluid head

Operating Instructions

The operating instructions are described in six steps. Please

read and understand these instructions before using this

equipment. Do not omit any steps.

1 Fluid Head Set-up

1.1 Loosen the PAN HANDLE CLAMP fully then rotate the

PAN HANDLE until it is approximately perpendicular to the

THREADED STUD (ﬁg. 5) and tighten the PAN HANDLE

CLAMP - avoid contact wear between the serrations

on the Fluid Head and the PAN HANDLE CLAMP , if this

occurs then unwind the PAN HANDLE CLAMP further.

1.2 Ensure

that

the

TRIPOD

horizontal. Place the Fluid Head into the TRIPOD BOWL,

adjust the BUBBLE LEVEL (ﬁg. 5) such that the bubble is

inside the black circle and tighten the CLAMP NUT.

1.3 Set the initial control settings as follows – see Figure 1 & 2:

Select Counterbalance to position 4 (top setting).

◗

Select Pan & Tilt Drag to position 0.

◗

Tighten the PAN LOCK, TILT LOCK and the SLIDING

◗

PLATFORM LOCK.

BOWL

approximately

Illumination Button

Bubble Level

Tripod Bowl

Threaded Stud

Clamp Nut

Fig. 5