Miller 16 CB PLUS 1107 Manuale dell'operatore - Pagina 8

Sfoglia online o scarica il pdf Manuale dell'operatore per Camera Accessories Miller 16 CB PLUS 1107. Miller 16 CB PLUS 1107 16. Fluid head

Operating Instructions

3. Camera Plate Lock Adjustment

3.1 The Camera Plate Lock is designed to secure the

CAMERA PLATE in a set position. The CiNX PLATFORM

can accept a third party (Arri type) CAMERA PLATE,

however, the Camera Plate Lock may need to be

adjusted to account for small dimensional variations

in third party CAMERA PLATES that can significantly

affect the locking function.

3.2 Pull and hold the SAFETY RELEASE PIN then pull the

SIDE LOAD LOCK LEVER outwards.

3.3 With the CAMERA PLATE in place, gently push the

SIDE LOAD LOCK LEVER towards the PLATFORM until

resistance is felt – this is the start of the locking action.

Check the position of the SIDE LOAD LOCK LEVER as

shown in (Fig. 9).

3.4 Adjustment is necessary if the SIDE LOAD LOCK LEVER

position is outside the recommended range. Follow

(Fig. 9) to determine the correct method of adjustment.

3.5 Using a 3mm Hex key unlock the LOCK SCREW

(fig. 8), then using a broad flat screw driver turn the

ADJUSTING SCREW (Fig. 8) in the direction shown

by 1/8 of a turn and re-check step 3.3, repeat 3.4 if

necessary. When adjusted correctly, the SIDE LOAD

LOCK LEVER will be smooth to operate and requires

modest effort to lock the CAMERA PLATE (Fig. 9).

3.6 Once the correct adjustment is achieved, remove the

CAMERA PLATE and tighten the LOCK SCREW (fig 8).

Locking Screw

Unlock

Lock

Platform

Safety Release Pin

8 8

Adjusting Screw

3mm Hex Key

Flat Screwdriver

Side Load Lock Lever

Fig. 8