Miller XT60 Manuale - Pagina 26
Sfoglia online o scarica il pdf Manuale per Torcia elettrica Miller XT60. Miller XT60 40.
5-2. Sequence Of Cutting Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
!
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
OM-254 449 Page 22
For standard (shielded) cutting, place drag shield on edge
of metal. For extended (non-shielded) cutting, use 1/8 in.
(3.2 mm) standoff distance (dragging tip will reduce tip life).
After cutting arc starts, slowly
start moving torch across metal.
Pause briefly at end of
cut before releasing trigger.
90
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
Ref. 254 087-A