AQUAPHOR RO-31 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di filtrazione dell'acqua AQUAPHOR RO-31. AQUAPHOR RO-31 12. Drinking water machine
Anche per AQUAPHOR RO-31: Manuale di istruzioni (17 pagine)

Stampa la pagina

6. STARTING THE RO

To start the RO, it is necessary to connect the supply tubes and carry out the washing procedure of the

cartridges

Step 1 – Connect the delivery tubes according to fig. 2.

Blue tube – from the connection node to the inlet collector block fitting.

Blue tube – from the inlet fitting of the conditioning block to the inlet conditioning cartridge fitting

(if necessary, shorten the tube).

Red tube – from the saddle to the drain fitting of the collector block.

White tube – from the end of the clean water tip to the outlet fitting of the conditioning cartridge.

Figure 7a

Figure 7b

• For cartridge connection press the button and turn the cartridge counterclockwise (fig. 8b).

Step 3 – Flush the RO.

• Open the inlet valve;

• Insert the tip into the socket of the web clipper (fig. 14а), holding it above

the sink;

• Holding the tip with your hand , put the web clipper in the sink, drain the

water out from the water purifier for 10 minutes;

• Disconnect the tip from the web clipper by pressing the button located on

the slam end (fig. 14b);

• Close the inlet tap;

• Place the modules in the "For operation" position (see fig. 9);

• Open the inlet tap;

• Insert the hand piece into the slot of the storage container lid;

• Wait for the water to enter the storage tank and drain the water;

• Repeat this procedure 2 times.

How to connect the tubes (fig. 7a)

Remove the locking clip from the plastic sleeve. Insert

the pre-wetted end of the tube into the nozzle sleeve until

it stops at a depth of approximately 15 mm (0,6 inches) and

put the locking clip back .

Check the strength of fixing the tube: with a force of

8–10 kgf (78,4–98 N) the tube should not be pulled out.

How to disconnect the tubes (fig. 7b)

To disconnect the tubes pull the locking clip out from

the plastic sleeve by pushing the butt of the plastic sleeve,

then pull the tube.

Step 2 – Install the filter cartridges.

•

Remove thermostatic tape and transporting plugs from

the cartridges.

•

Make sure, that the inside surfaces of the subunit flange

cartridges are clean (no coal dust, debris, etc.). If there is

any dust, flush it under water.

•

According to the (fig. 9) "the position of the cartridges In

the RO", install the cartridges in the position "for

flushing". For this insert the cartridge up to the stop to

the appropriate collector and turn it in a clockwise

direction until you hear a click (fig. 8а).

Figure 8a

Figure 8b